Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

how to configure media resources

There are 2 type of media resources

Software and Hardware.

How to add hardware media rescource on CUCM.

5 REPLIES
Cisco Employee

how to configure media resources

Hi,

Refer the below link for configuring the Hardware media resources in CUCM and Router.

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a00807f8b30.shtml

Regards,

Gnan.

New Member

how to configure media resources

sccp local Loopback100

sccp ccm 10.X.X.X identifier 2 version 7.0

sccp ccm 10.X.X.X identifier 1 version 7.0

sccp

!

sccp ccm group 1

associate ccm 1 priority 1

associate ccm 2 priority 2

associate profile 3 register abc_MTP

associate profile 2 register xyz_XCODE

associate profile 1 register mno_CONF

!

dspfarm profile 2 transcode

codec g711ulaw

codec g711alaw

codec g729ar8

codec g729abr8

maximum sessions 12

associate application SCCP

!

dspfarm profile 1 conference

codec g711ulaw

codec g711alaw

codec g729ar8

codec g729abr8

codec g729r8

codec g729br8

maximum sessions 4

associate application SCCP

!

dspfarm profile 3 mtp

codec g711ulaw

maximum sessions software 10

associate application SCCP

Can you explain what type of this media resources are? Software or hardware

In CUCM, all above 3 are configre by ip address

Cisco Employee

how to configure media resources

XCODER and CFB on IOS ALWAYS use DSPs,  so they're HW.

MTPs can be either SW or HW on IOS. Either they use DSPs or CPU/Memory from the ISR.

That MTP config already mentions what kind it is.

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

how to configure media resources

I saw in cucm that mac address option while adding media resources. whats this???

Lets say if if any of the above media resources are not registered in call manager, then that site cant used these resources to use them. I means to say if site A media resources (CFB is not registered due to any case) then Site A users cannot make conferencing with Site B ?

Cisco Employee

how to configure media resources

I would strongly recommend you to fully review the SRND media resources chapter before anything else.

How MRG and MRGLs is explained there and that addresses your question.

Short answer: just as if a phone is not registered you cannot call it, if a media resource is not registered it's useless. That is addressed via MRGL/MRG but for that you need to review the SRND.

Whether to use MAC address or not depends on where the resources are, you can find the explanation by reviewing the CUCM help.

On the page where you saw the MAC address click help -> for this page.

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
1216
Views
5
Helpful
5
Replies