How to configure trunk hunting in SIP trunk number range
I would like to know if its possible to configure trunk hunting from a given range of nubers from an ITSP?
I am using a CME. I have been given a number range e.g. 1231234500-1231234599
What i want to accomplish is i will make the number 1231234500 as the pilot number so callers will only need to call this number is another calls comes in it will be taken by the next number available in the range.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...