We are testing the integration with our partner right now with VG224 & CCM 4.1.x. I saw some document mentioned that the VG224 need to be configured as MGCP gateway, create the fxs port and indicate the SMDI port number. The SMDI port number need to be different for each port e.g. fxs 2/0 port no. 0, fxs 2/1 port no. 1, etc. It depends on how many analog ports for the voicemail. Then create route list/group for the analog ports and create route pattern for (the pilot of the voicemail) and route to the route list. Enable Cisco Messaging Interface and check with your third party voicemail system about the serial port communication parameter such as baud rate, data bits, parity, DN length, etc. Configure them from the Service Parameters of Cisco Messaging Interface. Of course you need to connect the serial between CCM and voicemail system.
We have done the above settings and able to communicate with voicemail system. We got the simulated signal about MWI on from voicemail system but CCM doesn't turn on the MWI. We are still under investigation. You can try those settings and see whether it work.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...