My client has a few extensions configured with an 'access door' feature so when the number is dialled a remote doorlock is unlocked. One of the doors does not close properly and each time it 'bounces' on the latch a CDR is being generated. As some of the doors are very busy the CDR logs are getting clogged up with these doors in contant use. I have read though some CDR configuration notes and have found some sections on disabling CDR (entirely) or using the RTMT to clear the CDR/CMR buffers, but nothing that can be configured on a specific extension.
The current version of CUCM is 4.1 but the site is being migrated to CUCM8.5 at present.
If anyone has any pointers or needs further information please ask!
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...