Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

How to disconnect an active T1 call in MGCP

I have a call that seems to be hanging on the T1 controller. I am running MGCP to the CUCM, how do I disconnect the single channel without disconnecting the rest of them? (Channel 23)

(Routerhostname)#sho voice port summary | inc 0/1/0:23
0/1/0:23       01  xcc-voice   up    up   none     none     y
0/1/0:23       02  xcc-voice   up    up   none     none     y
0/1/0:23       03  xcc-voice   up    up   none     none     y
0/1/0:23       04  xcc-voice   up    up   none     none     y
0/1/0:23       05  xcc-voice   up    up   none     none     y
0/1/0:23       06  xcc-voice   up    up   none     none     y
0/1/0:23       07  xcc-voice   up    up   none     none     y
0/1/0:23       08  xcc-voice   up    up   none     none     y
0/1/0:23       09  xcc-voice   up    up   none     none     y
0/1/0:23       10  xcc-voice   up    up   none     none     y
0/1/0:23       11  xcc-voice   up    up   none     none     y
0/1/0:23       12  xcc-voice   up    up   none     none     y
0/1/0:23       13  xcc-voice   up    dorm none     none     y
0/1/0:23       14  xcc-voice   up    dorm none     none     y
0/1/0:23       15  xcc-voice   up    dorm none     none     y
0/1/0:23       16  xcc-voice   up    dorm none     none     y
0/1/0:23       17  xcc-voice   up    dorm none     none     y
0/1/0:23       18  xcc-voice   up    dorm none     none     y
0/1/0:23       19  xcc-voice   up    dorm none     none     y
0/1/0:23       20  xcc-voice   up    dorm none     none     y
0/1/0:23       21  xcc-voice   up    dorm none     none     y
0/1/0:23       22  xcc-voice   up    dorm none     none     y
0/1/0:23       23  xcc-voice   up    up   none     none     y

Everyone's tags (5)
1 REPLY
Hall of Fame Super Red

Re: How to disconnect an active T1 call in MGCP

Hi Michael,

Have a look at this good doc. You will need to have set this up and reset

the Gateway at least once for it to work. But this may really help you moving

forward

Busy-Out ISDN B-Channels in Cisco CallManager Configuration Example

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_configuration_example09186a008076f8d2.shtml

Cheers!

Rob

427
Views
0
Helpful
1
Replies
CreatePlease to create content