Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

How to edit calling party number while on call forward?

Hi Guys,

We have a little problem with our Callmanager 4.1.3

When we activate call forward on IP-Phones to our Mobile Phones we get the calling party number with a leading "0".

On the CCM-environment it is usefull because we use "0" to ring out into PSTN.

But when we forward a call to our mobile phones this leading "0" is not needed and the phone number must be edited before it can be dialed on mobile devices.

Is there a possibility to edit the calling party number when the call is forwarded ?

greetings Christian

2 REPLIES
Cisco Employee

Re: How to edit calling party number while on call forward?

yes, configure a CSS for CF that reaches a translation pattern that strips the 0 before sending the call. just be aware you will need another route pattern without the 0 to route the calls to the outside, or create a separate route pattern and strip the 0 there. your choice as either would work

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
Community Member

Re: How to edit calling party number while on call forward?

Thanks for your reply, I will try it out tomorrow.

Maybe a have to take a look at the gateway if this does any number manipulation.....

154
Views
3
Helpful
2
Replies
CreatePlease to create content