Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to enable the comand debug isdn q931?

Hello

I have a gateway Cisco 2851.

I enable the commands via telnet and console:

router# debug isdn q931

router# terminal monitor

But eventhough there are incoming and outgoing calls from PSTN E1 ISDN PRI.

I DO NOT SEE ANY DEBUG.

Should I enable other commands in order to see these debug????

Regards

Walter

1 REPLY
Hall of Fame Super Gold

Re: How to enable the comand debug isdn q931?

you may have logging debug set to buffer that is, no debug out to console. Check with show logging.

Hope it helps, please rate all useful posts!

1282
Views
0
Helpful
1
Replies