I am on CUCM 8.5 and would like to get a list of DN that are used anywhere in the system. I.e., I use the 14xx area for things like Unity VM ports and my Contact Center lines etc. I know that I can go to Call Routing then Directory Number and it will show me the DN's as they are used and that works for almost all of them. However, I also know that, for instance, my number 1498 and 1499 are defined to turn the MWI on and off but that they do not show up in the list when I look at Call Routing, then Directory Number and search DN starting 14.
I beleive those are the only two but would really like to be sure before I started using another number someplace only to find I was breaking something (I actually did that once).
Is there a way of getting a report that would show if a number was used anyplace in the system at all?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...