Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

How to have access with callmanager to 411 and 311 using a 2811, dial patte

We have callmanager 4.1 using a 2811 router but even thought we have the pattern [49]11 in call manager we cant reach 411..Is there a dial peer that i have to add in the 2811? if yes can you give me an example. Also we have already contacted telco in reference to this and they say that we are suppose to have access to 411? thank you for your time

5 REPLIES
Silver

Re: How to have access with callmanager to 411 and 311 using a 2

Is your 2811 and MGCP controlled gateway or an H323 gateway?

New Member

Re: How to have access with callmanager to 411 and 311 using a 2

Hi

This is a h323 gateway. For example this is the configuration for our 911

!

dial-peer voice 91 pots

description "911 CALLS"

destination-pattern 911

progress_ind alert enable 8

direct-inward-dial

port 0/0/0:23

forward-digits all

!

We dont want the use to have the digit 9 in front , so if they have to dial 911 all they have to is dial 911 and they will reach 911 even thought for every other call they need the 9 in front. Thank you for your time

New Member

Re: How to have access with callmanager to 411 and 311 using a 2

can i add the following peer

dial-peer voice 411 pots

description "911 CALLS"

destination-pattern 411

progress_ind alert enable 8

direct-inward-dial

port 0/0/0:23

forward-digits all

Will this work? considering that the route pattern at call manager is [49]11 and when a user dial 911 its goes to 911, so the same feature should work for dialing 411

New Member

Re: How to have access with callmanager to 411 and 311 using a 2

With the route pattern:

[49]11

you can reach numbers starting by:

411 or 911

so in the pots dial-peer to the telco you have to preview that, to reach all the numbers starting with 4 or 9 ...

New Member

Re: How to have access with callmanager to 411 and 311 using a 2

Hi

Yes I apply the same principle to create a dial peer for the gateway and it worked.

Thank you very much for all your help and comments

191
Views
0
Helpful
5
Replies