Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to make MGCP Redundance???

ccm-manager config server X.X.X.X

ccm-manager redundant-host Y.Y.Y.Y Z.Z.Z.Z

I wanna which these three ip address (X Y Z) belongs to?

Is X.X.X.X TFTP's IP address?

Y.Y.Y.Y & Z.Z.Z.Z is subscriber or Publish or other?

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Super Bronze

Re: How to make MGCP Redundance???

1. To configure redundant config server..example is shown below

2. 2nd...Yes the Ip addresses are the servers used for call processing. Depending on whether your publisher is performing call processing, you can put the 2 ip addresses, the first ip will be the primary call secondary server and the 2nd ip will be the 3rd processing server.

This will be like this in your ccm-group

server a

server b

server c

where server a is ocnfigured in your mgcp call agent config as follows:

mgcp call-agent 10.176.105.1 2427 service-type mgcp version 0.1

and server b abd c are configured as shown in the ccm-manager redundant host section

ccm-manager redundant-host 10.146.90.200 10.146.200.200

ccm-manager mgcp

ccm-manager music-on-hold

ccm-manager config server 10.126.5.200 10.127.7.80

ccm-manager config

Please rate all useful posts "The essence of christianity is not the enthronement but the obliteration of self --William Barclay"
5 REPLIES
Silver

Re: How to make MGCP Redundance???

X.X.X.X = TFTP Server (in most cases same as the publisher ip address)

Y.Y.Y.Y and Z.Z.Z.Z = both backup Cisco CallManager servers = Subscribers

HTH

New Member

Re: How to make MGCP Redundance???

Got it and thanks. More question,

1st If I have 2 tftp servers for redundance which located in 1 publish and 1 subscriber, so how to config 'ccm-manager config server X.X.X.X', if only one can be configed , how to Fault Tolerance.

2nd 'ccm-manager redundant-host y.y.y.y z.z.z.z' , I think these 2 address is the server which Call Process service located. Am I right? Or If I have only 2 CCM (1 publish and 1 subscriber), and both running Call Process, should I put these 2 ip add(Pub and SUB) here?

Thanks in advance

VIP Super Bronze

Re: How to make MGCP Redundance???

Before you ask more questions, why dont you rate posts!

Appreciate people before you ask for more!

Please rate all useful posts "The essence of christianity is not the enthronement but the obliteration of self --William Barclay"
New Member

Re: How to make MGCP Redundance???

sorry aokanlawon, done

VIP Super Bronze

Re: How to make MGCP Redundance???

1. To configure redundant config server..example is shown below

2. 2nd...Yes the Ip addresses are the servers used for call processing. Depending on whether your publisher is performing call processing, you can put the 2 ip addresses, the first ip will be the primary call secondary server and the 2nd ip will be the 3rd processing server.

This will be like this in your ccm-group

server a

server b

server c

where server a is ocnfigured in your mgcp call agent config as follows:

mgcp call-agent 10.176.105.1 2427 service-type mgcp version 0.1

and server b abd c are configured as shown in the ccm-manager redundant host section

ccm-manager redundant-host 10.146.90.200 10.146.200.200

ccm-manager mgcp

ccm-manager music-on-hold

ccm-manager config server 10.126.5.200 10.127.7.80

ccm-manager config

Please rate all useful posts "The essence of christianity is not the enthronement but the obliteration of self --William Barclay"
118
Views
10
Helpful
5
Replies
CreatePlease to create content