how to page to fxs port and all ip hones at the same time
I have read a lot of information regarding setting up an overhead paging system with an fxs port using ccme. So I have it all setup and working. I can dial the extension fine, and page through the overhead system fine, but how do I configure the router so when I page to all ip phones, it also goes to the fxs port? I know I can use an ata 188 or 186, but can I use a standard fxs port on a voice card? Thanks for your help
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.