How to prevent phone display from being updated with digit manipulation?
I have a UCM 8.6 setup routing to a CUBE for PSTN calls. The signaling is as follows:
Phone <-- SCCP --> UCM <-- SIP --> CUBE <-- SIP --> ISP/PSTN. I know that if I were using the CUBE as an H323 gateway, I could use "
o supplementary-service h225-notify cid-update" to prevent the phone display from updated with the digit manipulationi in the dialed number. Does anyone have any suggestions on what the SIP equivalent command would be?
I've tried something as described in this blog, but it did not work...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.