Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

how to reboot Unity Express Module?

cisco 2821 gateway router with CME

We are experiencing an issue with voicemail. the inbound calls get busytone after a few rings. Does anyone know how to reboot Unity Express module on gateway router? or any ideas of what I need to do?

Thanks in advance!

1 ACCEPTED SOLUTION

Accepted Solutions

Re: how to reboot Unity Express Module?

I thought the command sequence was "offline" followed by "reload". This assumes you are executing the commands while connected to the service module. If you can't get into the service module, then I think the command sequence to reset the module is: "service-module service-engine / restart".

For example:

router# service-module service-engine 1/0 restart

I am going from memory here and am a little fuzzy. So, keep that warm and fuzzy note in mind.

HTH.


Regards,
Bill

HTH -Bill (b) http://ucguerrilla.com (t) @ucguerrilla

Please remember to rate helpful responses and identify

1 REPLY

Re: how to reboot Unity Express Module?

I thought the command sequence was "offline" followed by "reload". This assumes you are executing the commands while connected to the service module. If you can't get into the service module, then I think the command sequence to reset the module is: "service-module service-engine / restart".

For example:

router# service-module service-engine 1/0 restart

I am going from memory here and am a little fuzzy. So, keep that warm and fuzzy note in mind.

HTH.


Regards,
Bill

HTH -Bill (b) http://ucguerrilla.com (t) @ucguerrilla

Please remember to rate helpful responses and identify

674
Views
5
Helpful
1
Replies