07-15-2008 08:21 AM - last edited on 03-25-2019 07:42 PM by ciscomoderator
I do not have Administrator userid and password.
Searched CCO with no success.
I know that default is cisco/cisco.
Solved! Go to Solution.
07-15-2008 09:19 AM
Use the same procedure as for any router model, send break via console at boot, etc ...
Please rate post if it helps!
07-15-2008 09:19 AM
Use the same procedure as for any router model, send break via console at boot, etc ...
Please rate post if it helps!
07-15-2008 09:40 AM
Da,
Thanks. I was using a terminal emulator that did not send
Password Recovery Procedures
http://www.cisco.com/en/US/products/sw/iosswrel/ps1831/products_tech_note09186a00801746e6.shtml
Needs updating. No mention of UC500 anywhere on CCO that I can find.
-- j
07-15-2008 09:52 AM
Putty rulez.
Thanks for the appreciation and good luck!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: