Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

How to set busy tone for 2nd call on CME?

With CM, we can set busy trigger to 1 and 2nd call will receive busy trigger.

But with CME, how to set busy tone for 2nd call?

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions

Re: How to set busy tone for 2nd call on CME?

If the ephone-dn is single line then your busy trigger is by default 1. You can set the busy trigger for a dual line ephone-dn by setting "huntstop channel."

PS: please remember to rate posts!

2 REPLIES

Re: How to set busy tone for 2nd call on CME?

If the ephone-dn is single line then your busy trigger is by default 1. You can set the busy trigger for a dual line ephone-dn by setting "huntstop channel."

PS: please remember to rate posts!

Community Member

Re: How to set busy tone for 2nd call on CME?

I configure it for dual-line, because I need conference feature.

What is the different between 'huntstop' and huntstop channel'?

Should I enable 'huntstop channel' for each ephone-dn?

Is this correct configuration for feature that I need?

ephone-dn 1 dual-line

number 1050011 secondary 2306

label 1050011

description Kakanwil

name Kepala Kanwil

huntstop channel

!

Thx

241
Views
11
Helpful
2
Replies
CreatePlease to create content