10-27-2014 10:13 AM - edited 03-17-2019 12:42 AM
Hello everybody!
I need to set Busy Trigger parametar to 1 for all the phones in CUCM.
I know how to do that for one phone in Line settings.
But how to do that for all devices?
10-27-2014 10:20 AM
Use BAT to do that.
10-27-2014 10:25 AM
Thank you for the response Jaime!
Could you be more specific with steps that I need to take?
I haven't been using BAT (Bulk Administration Tool) so far.
10-27-2014 12:45 PM
Something like that is pretty straighforward, just change the line settings, you can review the documentation for your version here:
http://www.cisco.com/c/en/us/support/unified-communications/unified-communications-manager-callmanager/products-maintenance-guides-list.html
Or just play around, with it a few minutes to grasp how it works.
10-28-2014 03:34 AM
Like Jaime said use BAT, see below screen shot to point you in the right direction. Just 'Find' all your lines, hit next and scroll to the 'Busy Trigger' check the box to say you want to update that field and enter your value in the box.
At the bottom of the page, select the 'Run Immediately' option then hit 'Submit'
Job done!
You can then go back into 'Bulk Administration' and 'Job Scheduler' to check the status of your update.
Hope that helps
Matty
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: