Like Jaime said use BAT, see below screen shot to point you in the right direction. Just 'Find' all your lines, hit next and scroll to the 'Busy Trigger' check the box to say you want to update that field and enter your value in the box.
At the bottom of the page, select the 'Run Immediately' option then hit 'Submit'
You can then go back into 'Bulk Administration' and 'Job Scheduler' to check the status of your update.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.