Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to setup Cisco 7937g CME 7.0

Hi All,,

         I will appreciate if anyone can enlighten me on how to configure a Cisco 7937G on a CCME router version 7.0...

Firmware to use and configuration steps will be good.....Urgent pls.

Thanks in advance

3 REPLIES

How to setup Cisco 7937g CME 7.0

Hi,

Please make sure to have all the 7937g phone load uploaded in the falsh and use the below link and the section "

Configuring Phones to Make Basic Calls" unde the chapter "Setting Up Basic Configuration" in the below link,

http://www.cisco.com/en/US/partner/docs/voice_ip_comm/cucme/admin/configuration/guide/cmebasic.html

example:

ephone-type 7937

device-id 431

num-buttons 1

max-presentation 6

.

.

.

.

.

.

.

ephone 2

mac-address xxxx.xxxx.xxxx

type 7937

button 1:2

.

..

here in the above example we have used ephone 2 and button2 for this 7937g phone.

Hope it helps.

Anand

Hall of Fame Super Gold

How to setup Cisco 7937g CME 7.0

anchoudh wrote:

ephone-type 7937

device-id 431

num-buttons 1

max-presentation 6

.

CME supports the 7937 natively, there is no need to create a custom ephone.

How to setup Cisco 7937g CME 7.0

I got this working by uploading the 7937 phone loads. Download it from Cisco software page. Note that before you can download the file you must have a valid service contract.

Downloads Home > Products > Voice and Unified Communications > IP Telephony > IP Phones

Cisco Unified IP Phone 7900 Series > Cisco Unified IP Conference Station 7937G >

Skinny Client Control Protocol (SCCP) Software-1.4(4)

Please rate replies and mark question as "answered" if applicable.
3118
Views
5
Helpful
3
Replies