How to setup IMAP for CUCMBE to check Voicemail Messages
Hi all, I have a CUCMBE installation and have a ton of Voice Messages in our "UndeliverableMessagesMailbox". When I try to check the mailbox by dialing the extension, the pin that I have reset a number of times, will not work and gives me an "invalid entry".
Moving forward, the amount that I need to check is huge and I thought possible checking the VM's via IMAP is the way to go.
Can anyone give me any steps in setting IMAP up? It does not need to be neat I just need to access these Voice Messages.
Here is my info:
Cisco Unified CM Administration System version: 184.108.40.2060-1
Re: How to setup IMAP for CUCMBE to check Voicemail Messages
Good deal. It's actually not too tricky IMO. However, many people get confused when looking at the System and Administration guides because a lot of information regarding SMTP and IMAP are lumped together in the same section of documentation and they should likely be handled separately from a documentation perspective. Glad to hear all is well.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...