Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to team 2 NICs of CCM 5.1

There are 2 MCS 7845 configured as CCM cluster. Each 7845 come with 2 NICs. How can I team these 2 NICs as a virtual one worked as active/standby mode ?

1 ACCEPTED SOLUTION

Accepted Solutions
Green

Re: How to team 2 NICs of CCM 5.1

With CM 5.X on a supported MCS HP Server this will work.

-You will have to ssh in or be on the console directly

-You enable it from command line on the server

-set network nic failover ena

-You will need to reboot the cluster

-Next, show status

-show network failover

Please refer to the link below for further information.

http://www.cisco.com/en/US/partner/products/sw/voicesw/ps556/products_im

plementation_design_guide_chapter09186a008063743a.html#wp1070947

Due to driver issues we don't support NIC teaming on IBM platforms as of

now.

3 REPLIES
Green

Re: How to team 2 NICs of CCM 5.1

With CM 5.X on a supported MCS HP Server this will work.

-You will have to ssh in or be on the console directly

-You enable it from command line on the server

-set network nic failover ena

-You will need to reboot the cluster

-Next, show status

-show network failover

Please refer to the link below for further information.

http://www.cisco.com/en/US/partner/products/sw/voicesw/ps556/products_im

plementation_design_guide_chapter09186a008063743a.html#wp1070947

Due to driver issues we don't support NIC teaming on IBM platforms as of

now.

New Member

Re: How to team 2 NICs of CCM 5.1

Any idea when teaming will be supported on the IBM platform? I have a 7825 I2.

Thanks,

Re: How to team 2 NICs of CCM 5.1

I know it works on 7835-I2 on 5.1

116
Views
10
Helpful
3
Replies
CreatePlease login to create content