Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

How To Transfer an inbound call on FXO

Hi.i have a problem on transfering my inbound calls on fxo to a specific fxs port.i have connected my GW to pbx with one fxo line,so when i dial that spesific line number(on pbx) that is connected to my router after two beep router picks up the line and provides dial tone now i can dial my fxs port DN, but i want that when i call my GW it pick up and then automaticly transfer my call to a spesific fxs port,how is this possible.(i have tried incoming called-number X where X was one of my fxs numbers but it didnt work when i call my GW again it answers the line and provides dial tone for me but not transfering my call to specified fxs port number)

  • IP Telephony
1 REPLY
New Member

Re: How To Transfer an inbound call on FXO

Use the command "connection plar" on the FXO voice port. Use the DN of the FXS you want to connect to, and when the FXO answers, it will automatically place a call to the FXS port.

182
Views
3
Helpful
1
Replies
This widget could not be displayed.