Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

how to upgrade firmware on the Cisco IP Phone 7970 in CUCM 5.x

Hi frds,

Need your help here.i want to upgrade the firmware for one Cisco IP Phone 7970 in my cluster.Could you pls share any doc related to this.

Thanks in advance,

Shiv.

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Red

Re: how to upgrade firmware on the Cisco IP Phone 7970 in CUCM 5

Hi Shiv,

Just to add a note to the good help from Liz (+5 points here Liz :)

Under>Device>Phone>Phone Configuration

Firmware Load Information (leave blank to use default)

Phone Load Name

You can specify the firmware file name specifically under one phone and reset the phone so that it will upgrade to the new Firmware.

Hope this helps!

Rob

5 REPLIES
Bronze

Re: how to upgrade firmware on the Cisco IP Phone 7970 in CUCM 5

Good morning,

http://download-sj.cisco.com/cisco/voice/ip-7900ser/cmterm-7970_7971-sccp.8-3-4SR1-readme.htm

This link is to the text file relating to the 7970 firmware v 8.1(4)SR1. The installation instructions for 5.0 are listed.

You just need to log in with your CCO credentials and download the text, find the right firmware for your version and model phones and follow the instructions.

HTH

New Member

Re: how to upgrade firmware on the Cisco IP Phone 7970 in CUCM 5

Thanks for you reply..

i need to upgrade on only one IP phone right now.What should be done on CCM/Phone configuration side,so that the particular phone alone gets upgraded.Any Parameter if any ?

Thanks in advance,

Shiv.

Hall of Fame Super Red

Re: how to upgrade firmware on the Cisco IP Phone 7970 in CUCM 5

Hi Shiv,

Just to add a note to the good help from Liz (+5 points here Liz :)

Under>Device>Phone>Phone Configuration

Firmware Load Information (leave blank to use default)

Phone Load Name

You can specify the firmware file name specifically under one phone and reset the phone so that it will upgrade to the new Firmware.

Hope this helps!

Rob

Bronze

Re: how to upgrade firmware on the Cisco IP Phone 7970 in CUCM 5

Hi Shiv,

Rob so nicely covered your second question.

The reset will take longer than normal, and if you're able to watch, you can see it load the new firmware.

HTH and HAGD

New Member

Re: how to upgrade firmware on the Cisco IP Phone 7970 in CUCM 5

Thanks to everyone here who helped me out.

Shiv

540
Views
15
Helpful
5
Replies