Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Cisco Employee

How to verify DSP's physical location on Gateway

"show inventory raw / Diag " provides output of the DSP's location in the device like below,

 

NAME: "PVDM Slot :1", DESCR: "C2801 DaughterCard Slot"

PID:                   , VID:    , SN:

NAME: "PVDM 1", DESCR: "PVDMII DSP SIMM with Two DSPs"
PID: PVDM2-32          , VID: NA  , SN: FOCXXXXXXX

NAME: "DSP (C5510) 0/1/0", DESCR: "DSP (C5510)"
PID:                   , VID:    , SN:

NAME: "DSP (C5510) 0/1/1", DESCR: "DSP (C5510)"
PID:                   , VID:    , SN:

 

# How to indentify DSP which is located on Multiflex card [ Eg. VWIC2-1MFT-T1/E1] from the one inserted on Motherboard slot.

# Can I have / replace DSP which comes in Multiflex card ?

 

Thanks in advance for your support.

Regards,

Danial

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

VWIC cards have no DSPs built

VWIC cards have no DSPs built in, you need HDV card for external PVDMs, and "sh diag" shows if you have them properly via slot number.

Chris

2 REPLIES
Hall of Fame Super Silver

VWIC cards have no DSPs built

VWIC cards have no DSPs built in, you need HDV card for external PVDMs, and "sh diag" shows if you have them properly via slot number.

Chris

Cisco Employee

Thankyou so much Chris,,

Thankyou so much Chris,,

61
Views
0
Helpful
2
Replies
CreatePlease login to create content