Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Hunt Config in CEM 8.6

Hi,

I have configured the below hunt:

=============================================

voice hunt-group 1 sequential

list 000,001,002,003

timeout 15

pilot 004

=============================================

The problem that i am facing is: once it rings 003, it keeps on ringing for ever...Kindly sugegst what needs to be done...

9 REPLIES
Hall of Fame Super Red

Re: Hunt Config in CEM 8.6

Hi there,

Try the "Final" command

voice hunt-group 1 sequential

list 000,001,002,003

final xxxx where xxxx = the DN you want to forward to (like VM pilot#)

timeout 15

pilot 004

Cheers!

Rob

New Member

Re: Hunt Config in CEM 8.6

Hi Rob,

There is no VM. I tried the final command & gave 003 (the last phone in the hunt)..But no success…

Rgds,

Partha

Hall of Fame Super Silver

Hunt Config in CEM 8.6

Is 001 registered, can you call it directly?

Chris

New Member

Re: Hunt Config in CEM 8.6

Yes..i can call 001..

Hall of Fame Super Red

Hunt Config in CEM 8.6

Hi Partha,

Do you want it to stop @ 003 and ring forever? Or

start the cycle over again?

Cheers!

Rob

New Member

Re: Hunt Config in CEM 8.6

Hi Rob,

I wish to stop the hunting at 003.

Rgds,

Partha

Hall of Fame Super Red

Hunt Config in CEM 8.6

Hi Partha,

You could try;

timeout 15,15,15,180

Which would allow 3 minutes (180 seconds) for 003 to answer

Cheers!

Rob

New Member

Re: Hunt Config in CEM 8.6

Hi Rob,

I tried your solution. But it’s not working for me…

Rgds,

Partha

New Member

Re: Hunt Config in CEM 8.6

Hi Partha,

You can configure the "hops 3" command under the voice hunt-group 1 sequential to stop hunting at 003.

Regards,

Pratik

341
Views
0
Helpful
9
Replies
CreatePlease login to create content