Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Hunt Group CME 8.6 Configuration

Hi!

I just installed a new CME 8.6 with 20 ephones 9621 sccp. I need to create a hunt group ringing 3 seconds and if noan or busy, ring the next one.

I followed these steps but stills fails, what could be the problem?

voice hunt-group 1 parallel

pilot 1000

list 4010, 4011, 4012, 4013

final 4013

timeout 20

I tried to with the ´noan and busy command´ but does not working. When I call to a ephone, rings and after 10 seconds tried to forward the call to the next one, but instead of do that, drop calls.

Waiting for your responds.

Regards!                   

2 REPLIES
Hall of Fame Super Gold

Hunt Group CME 8.6 Configuration

You should avoinf parallene hunt-groups as they don't work very well. Used instead sequential ephone-hunt, or shared lines.

New Member

Hunt Group CME 8.6 Configuration

The problem was already resolved, the pilot number must to be the same that the one I used in voice traslation-rule to receive incoming calls.

regards.

388
Views
0
Helpful
2
Replies
CreatePlease login to create content