Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Hunt Group

Hi,

I am configuring a hunt pilot, say 8888 and I would like incoming PSTN calls to 12345678 to use the hunt pilot number 8888 to reach DNs in the hunt list.

I know this can be done using a translation rule in the h323 gateway,

Is it possible to use Call manager to do the transformation or translation instead. How do you transform 12345678 to 8888 ?

Any help appreciated.

Thanks,

Paul

5 REPLIES
Cisco Employee

Re: Hunt Group

Good morning, Paul.

Do you intend to run the gateway as H.323 or MGCP?

New Member

Re: Hunt Group

It is running h323. If I decide not to use a translation pattern at the h323 gateway.

How do you go about doing it in call manager ?

Thanks

Re: Hunt Group

simple

on the gateway setting page make sure that the significant digit set to all

and on the dial-peer on the gateway make sure that the gateway will sedn the whole number to ur CCM

on callmanager creat a trnaslation pattren with pattren set to 12345678

give the translation pattren a partion the is accessable by the gateway CSS the gateway CSS must include this translation pattren partion

give the translation pattren a CSS that has access to the hungroup partion

now in the buttom of the translation pattren settin page there a called number trasnformation mask put it as 8888

thats it

but make sure u have check every point i mentioned above to get it work

good luck

if helpful Rate

Cisco Employee

Re: Hunt Group

Great reply - beat me to it while I was away from my keyboard.

+5 from me!

Re: Hunt Group

ohh thanks :)

176
Views
5
Helpful
5
Replies
CreatePlease login to create content