I'm trying to display the hunt pilot alerting name on a group of phones using a broadcast line group.
I've followed several forum posts on creating a CTI RP and using CFA to fwd to hunt pilot. This solution works in house from a phone directly on the system, However outside calls only shows ANI (CLID) of incoming call. There is a brief sign of "Forward XXXX Hunt Group" displayed on the LCD but them immediately the CLID overwrites.
I've done that on the CTI RP line DN already. What is does is allow the Forwared XXXX Hunt group message to briefly display on the LCD but the ANI immediately overwrites it and if you're not staring at the phone when the call comes in you'll never see it.
Is there a way to not show the ani? Again, if i call the RP DN from an interal phone the problem doesn't happen. Only the DN alerting name show in this case.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...