I need configure hunt pilot to after rotate all and anybody it attend, transfer to voicemail of the called subscriber. It's possible? My version is callmanager 4.2.3(sr2b). Ex: I call to 6000, but the phone is not registered and your configuration is "Forward Unregistered Internal": 7000 (hunt pilot number). After hunt pilot rotate all phones on line group, the voicemail greeting to extension 6000. It's possible?
Another alternative is to add your VM Line-group to your existing huntlist for the pilot 7000.
Configure the Line-group settings to Try next member, then, try next member in HuntList for Callforward Busy, No Answer and unavailable.
This will drop the call into Unity, then it is simply a cause of creating a Direct Call routing entry within Call Routing. Configure the rule to route the dialed number 6000, and set the send to greeting for the appropriate subscriber.
On Hunt Pilot configuration, "Hunt Forward Settings" section, "Forward Hunt No Answer" and "Forward Hunt Busy" fields, I put the number of the unity. And so, when the hunt pilot rotate all, will direct to unity and the unity route to voice mail from subscriber.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...