Hunt Pilot to VM - MWI Light on all Line Group Member's Phones
Scenario is - a customer is looking to setup a Hunt Pilot-type config with a DDI that does a broadcast to all members of an associated Line Group. If nobody picks up, then he wants the caller to be directed to a mailbox that is associated with the Hunt Pilot, not any individual member of the Line Group. He then wants all users of the Line Group to be aware that a message has been left by means of the MWI light on their phone, so there is a MWI in multiple locations.
Is this possible? If so, how is it configured, and if not, is there another way to implement this?
Setting Up Alternate MWIs for Extensions on the Same Phone Syste
Cisco Unity can activate alternate MWIs for extensions on the same phone system. Note that depending on the phones and phone systems, some additional phone system programming may be necessary. Refer to the installation guide for the phone system.
To enable alternate MWIs for extensions on the same phone system, do the following procedure for each subscriber who needs alternate MWIs.
To Set Up Alternate MWIs for Extensions on the Same Phone System
Step 1 In the Cisco Unity Administrator, go to the applicable Subscribers > Subscribers > Messages page.
Step 2 Confirm that the Use MWI for Message Notification check box is checked.
Step 3 Click the Add button located beneath the MWI Extensions table to add a row to the table. By default, the first row in the table contains an "X" to indicate the primary extension assigned to a subscriber. If you want one more extension and do not need to activate the MWI on the primary extension, you can also modify the first row.
Step 4 Enter the applicable extension in the Extension field of the table. MWIs are automatically enabled for all rows in the table. When entering characters in the MWI Extensions table, consider the following:
Enter digits 0 through 9. Do not use spaces, dashes, or parentheses.
Enter , (comma) to insert a one-second pause.
Enter # and * to correspond to the # and * keys on the phone.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.