Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Hunt Pilot using VG224 analog lines

I'm trying to setup a hunt pilot using serveral analog lines from my vg224.  When I use these DN numbers assoicated with the VG

224 I get a busy signal.  if I use any other DN number, such as an IP phone the Hunt pilot works correctly.  Since it works correctly with

the IP Phone DN number, I'm guessing I have the hunt pilot configured correctly.  Is there any reason why it won't work with DN numbers assoicated with a VG224 device?  I'm using Call Manager 6.1.4.2000-5.  VG224 IOS is 12.4(24)T3

Thanks

Mike C.

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Red

Re: Hunt Pilot using VG224 analog lines

Hi Mike,

The VG224 ports are "logged out" of Hunt Groups by default.

If you put a tick in the "Logged into Hunt Group" box at the Device Level on the VG224 that should fix it."

Hope this helps!

Rob

Please support CSC Helps Haiti

https://supportforums.cisco.com/docs/DOC-8895

https://supportforums.cisco.com/docs/DOC-8727

4 REPLIES
Hall of Fame Super Red

Re: Hunt Pilot using VG224 analog lines

Hi Mike,

The VG224 ports are "logged out" of Hunt Groups by default.

If you put a tick in the "Logged into Hunt Group" box at the Device Level on the VG224 that should fix it."

Hope this helps!

Rob

Please support CSC Helps Haiti

https://supportforums.cisco.com/docs/DOC-8895

https://supportforums.cisco.com/docs/DOC-8727

New Member

Re: Hunt Pilot using VG224 analog lines

Rob,

Thanks so much for the quick response...  Its working now.

Cheers

Mike

Hall of Fame Super Red

Re: Hunt Pilot using VG224 analog lines

Hey Mike,

Glad to be of some small help here my friend

Cheers!

Rob

Bronze

Thanks, the post was helpful

Thanks, the post was helpful for me also

633
Views
0
Helpful
4
Replies