Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

HW Config : 2951 & voice PRI card

Hello experts,

We have a C2951 router and we want to connect a PRI line on it for voice calls. I am confused as to which specific card/module should buy for this job. Any ideas?

Thank you in advance for your answer

Nikos

Everyone's tags (3)
1 REPLY

Re: HW Config : 2951 & voice PRI card

Nikos,

There are several options available to you.  Take a look at this link for the options:

http://www.cisco.com/en/US/products/ps10536/products_relevant_interfaces_and_modules.html#voicemod

This module is a good candidate based on your high level description:

VWIC2-1MFT-T1/E1
1-port T1/E1 Voice / WAN w/ Drop &  Inser

In addition to the T1 module, you will need DSPs. DSPs are used by the router for voice termination, media mixing, transcoding, etc.   DSPs for the ISR (and ISR G2) are provide on carrier cards called PVDMs.   Your router support the PVDM3  (generation 3).  Review this sheet to help you pick the PVDM that is right for you:

http://www.cisco.com/en/US/partner/prod/collateral/modules/ps3115/data_sheet_c78-553971_ps10537_Products_Data_Sheet.html

HTH.

Regards,
Bill

Please remember to rate helpful posts.

HTH -Bill (b) http://ucguerrilla.com (t) @ucguerrilla

Please remember to rate helpful responses and identify

623
Views
9
Helpful
1
Replies
CreatePlease login to create content