Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

I can call from Branch through Gatekeeper to CUCM. But cannot call from CUCM through Gatekeeper to any Branche.

 

Hello All,

 

 

I can Call from any Branch office to CUCM through Gatekeeper. But I cannot call from CUCM through Gatekeeper to any Branch.

My CUCM version is 9.1.2

 

 

Regards

Bahlul

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Do you see anything shw up on

Do you see anything shw up on the debugs on the branch router?

Check debug h225 asn1 to see if there is a setup coming from the CUCM. If not, that means the CUCM is not receiving the IP address of the branch gateway from the GK. This could mean a config issue on the GK with respect to the branch gateways, or on the UCM.

Take debug gatekeeper main 10 from the gatekeeper. These debugs will show what's happening on the GK while processing the incoming ARQ from CUCM.

Also please upload the config of the GK, branch gateway here.

 

Hantale

Sree

3 REPLIES
Cisco Employee

Do you see anything shw up on

Do you see anything shw up on the debugs on the branch router?

Check debug h225 asn1 to see if there is a setup coming from the CUCM. If not, that means the CUCM is not receiving the IP address of the branch gateway from the GK. This could mean a config issue on the GK with respect to the branch gateways, or on the UCM.

Take debug gatekeeper main 10 from the gatekeeper. These debugs will show what's happening on the GK while processing the incoming ARQ from CUCM.

Also please upload the config of the GK, branch gateway here.

 

Hantale

Sree

New Member

Hello Sreekanth,The problem

Hello Sreekanth,

The problem was in Tech Prefix. I deleted it from Trunk configuration in CUCM, and everything become to work normally. Thanks a lot.

 

Rgards

Bahlul

Cisco Employee

Great! Glad I could help!

Great! Glad I could help!

62
Views
5
Helpful
3
Replies