I can make a call phone but extension doesn't receive the call
I have a UC540 and two lines connected
When I make a call phone to one line, everything it is ok. However when I make a call for other line I can hear the call signal, but the extension doesn´t ring and doesn't receive any notification of the call. I tried change the extension but the problem keeps.
When I do a test with CCA "Dial Plan Test" the result of test is correct.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.