Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

I cannot change some Clusterwide service parameters (CCM 6.0.1)

Hi,

I'm trying to change two sevice parameters (Auto Call Pickup Enabled and Transfer On-hook Enabled). But when I modify them and press "Save" button, Adminitration hangs up ("Loading, please wait" message) and I cannot change these values.

In previous releases (4.2), I could change it without any problem, but in this release I cannot do it.

Any idea?

Regards

1 REPLY
Community Member

Re: I cannot change some Clusterwide service parameters (CCM 6.0

Hi Antonio,

You didn't mention the version on which you're getting this behaviour, but it could something with the Browser you're using.

Using Firefox 2.something I experience sometimes simulair behaviour with CUCM 5.x/6.x. When I change to Internet Exlorer 6.0 this normally dissappears! Try swapping if you're also using an non-IE 6 browser.

Regards,

Eric

228
Views
0
Helpful
1
Replies
CreatePlease to create content