Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

I have a Cisco Express 500. Does the smartport configuration IPPhone+Desktop run CDP thus require a Cisco Phone?

I have a CE500 PC-24 POE switch. I am configuring an IP phone on a IPPhone+Desktop smart port. The phone is not a cisco phone. Does this switch port configuration require a cisco phone? If so, Is there a different config which I can apply to the port which will enable the port to trust COS/DSCP values taqgged by the phone? I need to connect PC's to the phones.

6 REPLIES
Hall of Fame Super Gold

Re: I have a Cisco Express 500. Does the smartport configuration

It the phones is not cisco, it doesn't really matter. Alos, oyu shoud not worry about dcp/cos, it will not make any difference if thye are set or not.

New Member

Re: I have a Cisco Express 500. Does the smartport configuration

The phones will be tagging dscp 46. Will the switch reset the

value or will it trust the value?

Hall of Fame Super Gold

Re: I have a Cisco Express 500. Does the smartport configuration

It will not mess with it.

Even if it would, you would never have a problem anyway.


Please remember to rate useful posts clicking on the stars below.

New Member

Re: I have a Cisco Express 500. Does the smartport configuration

Allow me rephrase the question.

Will the switch Trust the DSCP tag from the

non-cisco phone with this configuration (IP

Phone + Desktop)?

Hall of Fame Super Gold

Re: I have a Cisco Express 500. Does the smartport configuration

Please read my posts above because I have answered your question twice already.

New Member

Re: I have a Cisco Express 500. Does the smartport configuration

Your answer is not

clear. What does "will not mess with it" mean? Does that mean the value will not be reset or does it mean I should not change anything?

375
Views
0
Helpful
6
Replies
CreatePlease to create content