Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

I need to setup 7800 Series IP Phones in the CUCM 8.6.2 which by default are not support but will work after install the software. Anyone have document from Cisco as I remember I seen once before.

I need to setup 7800 Series IP Phones in the CUCM 8.6.2 which by default are not support but will work after install the software. Anyone have document from Cisco as I remember I seen once before.

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Red

Re: I need to setup 7800 Series IP Phones in the CUCM 8.6.2 whic

Hi Ali,

I'll just add this reference to the good tips from my friend Manish (+5)

Support for the 7800 series in CUCM 8.6.2 was first added with this

Device Pack;

Cisco Unified Communications Manager

Device Package 8.6(2)(24104-1)Release Notes

Cisco Unified Communications Manager Device Package Release 8.6(2)

adds support for the Cisco IP Phones

7821, 7841, and 7861 running SIP firmware release 10.1(1).

The steps are in this doc

http://www.cisco.com/web/software/282074299/107528/cmterm-devicepack-8.6.2.24104-1_Readme.pdf

You might as well install the latest 8.6.2 Device pack

cmterm-devicepack8.6.2.24112-1.cop.sgn

Cheers!

Rob

"Seek it out and ye shall find  " 

- OneRepublic

5 REPLIES
New Member

I need to setup 7800 Series IP Phones in the CUCM 8.6.2 which by

If some one have steps that will save my time too. thanks

I need to setup 7800 Series IP Phones in the CUCM 8.6.2 which by

Hi Ali,

Please check this link

https://supportforums.cisco.com/thread/2256077

HTH

Manish

Hall of Fame Super Red

Re: I need to setup 7800 Series IP Phones in the CUCM 8.6.2 whic

Hi Ali,

I'll just add this reference to the good tips from my friend Manish (+5)

Support for the 7800 series in CUCM 8.6.2 was first added with this

Device Pack;

Cisco Unified Communications Manager

Device Package 8.6(2)(24104-1)Release Notes

Cisco Unified Communications Manager Device Package Release 8.6(2)

adds support for the Cisco IP Phones

7821, 7841, and 7861 running SIP firmware release 10.1(1).

The steps are in this doc

http://www.cisco.com/web/software/282074299/107528/cmterm-devicepack-8.6.2.24104-1_Readme.pdf

You might as well install the latest 8.6.2 Device pack

cmterm-devicepack8.6.2.24112-1.cop.sgn

Cheers!

Rob

"Seek it out and ye shall find  " 

- OneRepublic

Re: I need to setup 7800 Series IP Phones in the CUCM 8.6.2 whic

Thanks for adding some more useful info to this post Rob [+5] .

Manish

New Member

I need to setup 7800 Series IP Phones in the CUCM 8.6.2 which by

Thanks Guys

318
Views
10
Helpful
5
Replies
CreatePlease to create content