08-18-2008 08:55 AM - edited 03-15-2019 12:41 PM
Is there a way to tell if calls on my MGCP gateway are inbound or outbound on my T1 PRI ?
I was running the following commands, and none gave me an indication. I am sure there is a command for this...
sh voice call sum
sh voice call stat
sh call active voice brie
08-18-2008 09:07 AM
I normally just do a quick look at what channels are in use and then verify if telco is sending in top down and we are sending out bottom up.
Matt
08-18-2008 09:10 AM
Never thought about it that way....good idea.
08-18-2008 09:34 AM
you can also use CCM detailed traces. debugs voice ccapi inout and debug isdn q931
08-18-2008 10:36 AM
I was hoping to avoid debugs...but you are correct.
Thanks!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide