Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Identifying inbound vs. outbound

Is there a way to tell if calls on my MGCP gateway are inbound or outbound on my T1 PRI ?

I was running the following commands, and none gave me an indication. I am sure there is a command for this...

sh voice call sum

sh voice call stat

sh call active voice brie

4 REPLIES

Re: Identifying inbound vs. outbound

I normally just do a quick look at what channels are in use and then verify if telco is sending in top down and we are sending out bottom up.

Matt

Community Member

Re: Identifying inbound vs. outbound

Never thought about it that way....good idea.

Re: Identifying inbound vs. outbound

you can also use CCM detailed traces. debugs voice ccapi inout and debug isdn q931

Community Member

Re: Identifying inbound vs. outbound

I was hoping to avoid debugs...but you are correct.

Thanks!

119
Views
11
Helpful
4
Replies
CreatePlease to create content