Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

In CUCM 6/7, is it possible to bring up a primary node

in a cluster when the primary node(publisher) fails without restoring via DRS?

Just wondering if is it possible at all?

Let's say by using some dbreplication command to replicate the subscriber's data to rebuilt the publisher's database.

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Red

Re: In CUCM 6/7, is it possible to bring up a primary node

Hi Kinwai,

CCM 6.x and 7.x has the same design considerations as before when it comes to the Single Publisher with multiple Subscriber setup. My understanding is that Cisco is working on a method to promote a Sub to Pub for Disaster recovery purposes, but this has not yet been released. Soon I hope :)

Hope this helps!

Rob

2 REPLIES
Hall of Fame Super Red

Re: In CUCM 6/7, is it possible to bring up a primary node

Hi Kinwai,

CCM 6.x and 7.x has the same design considerations as before when it comes to the Single Publisher with multiple Subscriber setup. My understanding is that Cisco is working on a method to promote a Sub to Pub for Disaster recovery purposes, but this has not yet been released. Soon I hope :)

Hope this helps!

Rob

New Member

Re: In CUCM 6/7, is it possible to bring up a primary node

Hi Rob,

thanks a lot! Hopefully it will be possible soon!

I'm trying out the new CUCM 7 beta from cisco, i found a lot of new commands especially in "utils dbreplication",so just wondering if it's possible now.

Cheers,

kinwai

131
Views
0
Helpful
2
Replies