I'm the new CUCM SME at my workplace. The job was dumped in my lap with no training and I won't be getting any. I'm doing my best with online resources available.
We have a system running CUCM 4.3, and we have established an H.225 trunk for communicating with Tandberg VTC units. When a Tandberg unit dials a Voip phone (7965 or 7970), the incoming phone number is presenting as the number being called. The actual "Who" information is showing correctly. I have tried modifying settings in the trunk configuration page under "Inbound" and "Outbound" calls with no effect.
I was pretty excited when I saw this, so I jumped on the other network I maintain, that is running CUCM 8.5. Turns out that it's happening on that system as well. It should definitely be fixed in CUCM 8.5, right? Or am I missing something?
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...