Does annybody know If it is possible to modify inbound CLI (calls from the PSTN).
I have Call Manager V4.1(3)
Telco upgraded our 30 Channel E1 circuits to support CLI type 5. This was required for outbound CLI changes.
However on inbound calls from the PSTN they can only present 10 digits. This means that the leading zero is being dropped. IE, When a call is made from the PSTN to an IPT Phone the CLI appears as 1315887000. However this should appear as 01315887000.
Debug ISDN Q931 on the MGCP gateway confirms the inbound CLI as 1315887000.
Any suggestions If it is possible to Prefix a leading Zero to the CLI?.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...