I have a large list of translation patterns for outbound speed dials. Works fine for outbound, and of course we can mask the calling ID outbound
For inbound, Id like to have names attached to this same list, for example 18005555555 calls and I see "Bob's Plumbing". Its about 400 numbers and of course the PSTN only sends in a number. Whats the best way to do this? Translation seems to only be for numbering inbound
If I put them in a global directory would that accomplish it? If so, is there a way to bulk admin this from CUCM?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...