Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Inbound Dial-peer help

I have the below config setup on a H.323 router. I am trying to get the 303-555-5338 number to ring to a different target at 10.255.201.11. However, it never matches that dial peer. It always hits dial-peer 900. I thought the DP with the longest explicit match would be triggered. Thanks,

dial-peer voice 100 pots
destination-pattern 9T
incoming called-number .
direct-inward-dial
port 0/0/0:23
!

dial-peer voice 900 voip
tone ringback alert-no-PI
preference 2
destination-pattern 30355553..
voice-class codec 1
voice-class h323 1
session target ipv4:10.255.203.12
dtmf-relay cisco-rtp h245-alphanumeric
no vad
!

dial-peer voice 200 voip
destination-pattern 3035555338
session target ipv4:10.255.201.11
!

Everyone's tags (3)
3 REPLIES
New Member

Re: Inbound Dial-peer help

Yes you are correct, longest prefex wins....

http://www.cisco.com/en/US/tech/tk652/tk90/technologies_tech_note09186a008010fed1.shtml#topic9

You need to specify the codec under dial peer 200 similar to dial peer 900. I am guessing that dial peer 200 does not work so the router use DP 900 instead, you can shutdown DP 900 to confirm.

New Member

Re: Inbound Dial-peer help

Thanks.

I added the the missing pieces but it still is not triggering. This is a production router so I can't shut the dial-peer during the day.


dial-peer voice 100 pots
destination-pattern 9T
incoming called-number .
direct-inward-dial
port 0/0/0:23
!

dial-peer voice 900 voip
tone ringback alert-no-PI
preference 2
destination-pattern 30355553..
voice-class codec 1
voice-class h323 1
session target ipv4:10.255.203.12
dtmf-relay cisco-rtp h245-alphanumeric
no vad
!

dial-peer voice 200 voip
destination-pattern 3035555338
session target ipv4:10.255.201.11
tone ringback alert-no-PI
preference 2
voice-class codec 1
voice-class h323 1
dtmf-relay cisco-rtp h245-alphanumeric
no vad
!

New Member

Re: Inbound Dial-peer help

Dial-peer config looks good...  I would confirm that the device on the far-end is working and is configured to accept H.323 calls from this router.

409
Views
0
Helpful
3
Replies