Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

inbound dial-peer matching

Hi Guys,

here is the configuration that is running in my organiztion.as there is two call legs in each call and every call leg has to match dial-peer,as i didnt understand in the configuration below, call from cucm matches which dial-peer or it matches default dial-peer 0

i am asking inbound dial-peer from cucm to router???

!

dial-peer voice 1000 voip

description To CallManager -

preference 1

destination-pattern 42602..

voice-class codec 1

voice-class h323 1

session target ipv4:X.X.X.X
dtmf-relay h245-alphanumeric
no vad

!

dial-peer voice 1 pots

description ** incoming DID **

incoming called-number .

direct-inward-dial

!

dial-peer voice 100 pots

description ** To PSTN Service **

destination-pattern 9.T

port 0/2/0:1

!

1 REPLY
Community Member

inbound dial-peer matching

because ive never seen any dial-peer configured for this purpose execpt some time with answer-address but for dirct line

233
Views
0
Helpful
1
Replies
CreatePlease to create content