Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Inbound FXO calls on a remote router

Have a remote router in a small branch office that has 2 fxo cards set up. Have a tunnel on the T1 set back to Call manager 4.1(3) as an mgcp gateway. Have outbound calls set up and working. Not sure how to set up inbound calls. Can any one point me in the right direction. Want to find a way to have them show up as an extension or point them to an extension.

Thanks

Keith

1 REPLY
Silver

Re: Inbound FXO calls on a remote router

Two important things to remember:

1) You have to have make sure the MGCP enabled dial-peers appear before any H323 dial-peers. These are usually the dial-peers that start with 999 or something similar.

dial-peer voice 999020 pots

service mgcpapp

port 0/2/0

2) Then you have to add the following voiceport configuration for PLAR

voice-port 0/2/0

connection plar

Please rate posts if you find them useful

89
Views
0
Helpful
1
Replies