Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Inbound FXO Port Ring Issue CCME

Hello

I have an issue where one of my agents is having issues with inbound calls from the Telco. The call rings 3 times on the Telco side before ringing the FXO port on my router.

1861 Router with CCME Configuration is as follows:

voice-port 0/1/0

trunk-group FXO

connection plar opx 75303

caller-id enable

voice-port 0/1/1

trunk-group FXO

connection plar opx 75303

caller-id enable

dial-peer voice 1 pots

trunkgroup FXO

incoming called-number .

direct-inward-dial

telephony-service

sdspfarm units 2

sdspfarm transcode sessions 8

sdspfarm tag 1 xCoder

em logout 0:0 0:0 0:0

max-ephones 8

max-dn 48

ip source-address 172.28.XXX.XXX port 2000

auto assign 1 to 8

timeouts ringing 6

cnf-file location flash:

cnf-file perphone

load 7941 term41.default

load 7961 term61.default

time-zone 5

voicemail 55

max-conferences 4 gain -6

call-forward pattern .T

moh flash:MOHCCME.au

web admin system name admin password XXXXXXXX

dn-webedit

time-webedit

transfer-system full-consult

transfer-pattern .T

create cnf-files version-stamp 7960 Oct 03 2008 10:44:14

ephone-dn  1  dual-line

number 75303

ephone  1

no multicast-moh

device-security-mode none

mac-address XXXX.XXXX.XXXX

type 7941

button  1:1

Thanks

Dennis M. Ferree

3 REPLIES
Hall of Fame Super Gold

Re: Inbound FXO Port Ring Issue CCME

Do you have caller-id working ?

New Member

Re: Inbound FXO Port Ring Issue CCME

Yes Caller ID works when it rings the phone on the fourth ring.  The FXO port rings 3 times then on the 4 ring it rings the 7941 phone with caller ID, then it rings 3 more times on the FXO and 4th ring on 7941 no caller ID.

Hall of Fame Super Gold

Re: Inbound FXO Port Ring Issue CCME

Seems like router is waiting for caller-id to be delivered then.

You can verify that with "debug vpm signal", make sure you have service timestapm debug msec enabled.

There is also an option in "caller-id" to make it faster, can't remember the keyword now.

560
Views
0
Helpful
3
Replies
CreatePlease to create content