I have a 2821 running CME 4.0, connected to PSTN with 4 FXO lines on a VIC2-4FXO.
I have inbound DID calling working with "connection plar opx (extension)", but I am unsure of how to set up outbound calling. I want each phone to use its own FXO port both for inbound and and outbound calling.
Thanks! That's exactly what I needed. I had done that earlier, but I didn't do the translations correctly, so not only calls that started with '9' went to the dial-peers, causing internal extensions to not be able to call each other. This is a much better solution.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.