Inbound - Preserving Destination Number - Dial Peer/CallManager
We have a range of DIDs and need to present the destination number to the device (FaxPress) in a hunt group. If we use a translation pattern, we suspect the destination digits will not be preserved. We may have the same problem with the use of a hunt group. FaxPress has 8 internal numbers on CallManager, how can we round robin inbound calls with various destination numbers, preserving the destination digits so FaxPress can use them to deliver the inbound fax to the correct e-mail recipient?
Re: Inbound - Preserving Destination Number - Dial Peer/CallMana
Looking into creating CTI Port with a DN for every inbound number, than setting those lines to Call Forward All to the Hunt Pilot, this should preserve the destination/dialed number by the calling party for presentation to FaxPress.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...