Incoming call from PSTN to SIP softphone X-lite using CME 4.1
I am using CME 4.1 with two IP phones running "skinny" protocol. I have also register X-lite sofftPhone as a SIP phone and I can make the calls between X-Lite and IP Phones and vica versa.
I can also call any PSTN number from X-lite soft Phone.
I have DID enabled and every thing works, for an exampe when I call my number 01xxxxxxx11 - extension 11 (on Cisco IP Phone) the coresponding phone rings, and when I call the extension 01xxxxxxx21 (also Cisco IP Phone) it also rings.
But when I call the number 01xxxxxxx55 - 55 is the extension on my X-lite SIP Phone, instead of it to ring, I have a ringing on my Cisco IP Phone with extension 11.
Can some one help, resolve this problem, so when I call the number from outside, my coresponding x-Lite SIP phone rings,
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...