Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

incoming call not disconnecting

hi friends,

i am facing one issue,i am having 2811 with 4 port fxo,my problem is if somebody calls to my office it is ringing ,but if they dissconnect the call also still the phone is ringing.if they send busytone also same

plz provide me the solution

4 REPLIES
New Member

Re: incoming call not disconnecting

Try commands, supervisory disconnect

and

timeouts call-disconnect

timeouts wait-release

under voice-ports.

This should work.

New Member

Re: incoming call not disconnecting

i tried already tried with these commands

supervisory disconnect dualtone pre-connect

pre-dial-delay 0

no vad

timeouts call-disconnect 2

timeouts wait-release 2

timing hookflash-out 250

the result is same.

New Member

Re: incoming call not disconnecting

I had the same issue once,and it worked with me,after trying these commands:

supervisory disconnect dualtone mid-call

input gain 14

output attenuation -6

timeouts call-disconnect 2

timeouts wait-release 2

timing hookflash-out 150

Re: incoming call not disconnecting

Check this link for good explanation about FXO disconnect problem: http://www.cisco.com/en/US/tech/tk652/tk653/technologies_tech_note09186a00800ae2d1.shtml

185
Views
0
Helpful
4
Replies
CreatePlease login to create content